Make a Scroll Saw Ribbon Box

160 0 0
Published on March 18, 2015

This little gift box is perfect for jewelry or other small gifts. The ribbon is cut from a laminated board as a single piece. Use nicely contrasting woods for that little extra pop.

The pattern is pretty easy to cut just pay attention to the inside of the ribbon. Cut it last so you can measure for a good fit to the top of the box. The dimensions of the outside of the box will change a little after you sand the top and bottom flush. If you cut the ribbon before you sand it might not fit snug. Also notice the little extra pieces of ribbon on the bottom of the box. These allow the ribbon to fit all the way to the bottom of the box so don’t forget to add them.

Leave a Reply

Your email address will not be published. Required fields are marked *